Home > Error Code > Laser Error Codes

Laser Error Codes

Contents

DO NOT DO SO. We got it this morning and I have it installed. Also, can I get some instructions on putting in the rollers. If the error persists then the laser will need replacing. this contact form

Check the main motor’s cable to ensure that it is seated properly. 4. I truly appreciate it. If the printer is expecting a toner addition cycle but one is not detected, a 94x TMC Error is displayed. If error persists then the rollers and separation pad may need changing.

Hp Laser Printer Error Codes

What to do: Machine Error: 8203 Error Code: Recording Paper Jam: The recording paper sensors are detecting paper in the paper path which has most likely caused a jam. Error 52 Flash Full - Not enough flash memory for data requested to be stored. Errors are stacked up to 20 deep. If the printer is already plugged into a wall outlet, try another power source in the building that is independent of the one currently being used.

Veronica Casto Houston, TX It is nice to place anonline order & get to talk to an actual person. Also try printing from a different application. Check the wiring harness cable. Hp Printer Support This is because the feed roller kit needs replacing and the counter needs resetting.

The chip may be missing or defective or contain incorrect information. Hp Laptop Error Codes email with model, primary and secondary pattern for troubleshooting info. Replace printhead, system board or ribbon cable. Remove the printer from any UPS supplies, additional power supplies, or power strips. 2.

Turn the printer off and then on. Hp Warranty Check Back back to top How did we do? The pin should enter the tower on the HVPS and depress the cover switch. This motor may be faulty.

Hp Laptop Error Codes

Explanation: Switch the machine off and back on again. http://lasers.coherent.com/lasers/error-codes Explanation: You may have experienced some paper feed problems from the mp tray. Hp Laser Printer Error Codes If error persists, then the paper pick-up rollers may need replacing or the paper path need cleaning. Hp Printer Error Code List Pdf Error 63 Unformatted or Defective Disk The printer will ignore a disk it senses as defective.

Simplify the print job. http://jvmwriter.org/error-code/laser-printer-error.html ERROR 43 / ERROR 43 OPT INTERFACE This indicates a communication problem between the formatter PCA and an optional interface installed (such as a network card). Check the printer’s configuration. 3. What to do: Error Code: 32 Error Code: Density Sensor Shutter Failure: The density sensor has a protective cover that is operated by a solenoid. Hp Laserjet 600 M602 Error Codes

POR several times Check each board for secure ground. Query: SYST:FAUL? If nothing is found, then there may be a problem with the paper sensors. navigate here Explanation: Check that the document is set correctly on the feeder, and that it is not skidding.

If the error persists then the fuser assembly will need replacing. Hp Support Explanation: Switch the machine off and back on again. Explanation: Remove paper from exit tray.

Tech Support Support Home PageMaintenance Kit InstructionsOther instructionsTroubleshootingArticles, news, blog Featured Articles HP Error CodesEntering Service ModeService mode PIN codesCounterfeit parts challengeCold reset instructionsClearing maintenance countJetDirect Reference GuideHalf-way testRepetitive defect rulerTestimonialsInnovations

Bubble percentage is outside of tolerable range (~15% bubbles)Lumenis LightsheersE15 - The diode laser light output as measured by the console energy detector is too low System Stuck in "Cooling Mode" - We got it this morning and I have it installed. XX Description 00 memory error on the cartridge or 01 memory device not found 10.00.00 Black print cartridge 10.00.01 Cyan print cartridge 10.00.02 Magenta print cartridge 10.00.03 Yellow print cartridge Supplies What to do: Machine Error: 7D Error Code: Drum unit error: The Fax machine prints using a drum unit.

What to do: Machine Error: A2 Error Code: Document Jam: The machine has detected a problem with a page in the automatic document feeder. Continue button/indicator -> Press this button to start single sheet feeder or duplex printing. -> Press and hold this button to print the Report page. 2. If nothing is found, the feed rollers or document sensors may be defective. his comment is here If error persists, then the paper sensors may be faulty.

Check the I/O connections and make sure the proper media is being used. What to do: Error Code: A2 Error Code: Sending Document is too long: When sending a fax, the document sensors have detected that the outgoing fax is too long. Check and reseat the fuser and toner cartridge to make sure they are not hindering gear movement in the drive train. 3. We don't sell hard drives, monitors, software, mp3 players, or the zillions of other computer products sold by every other cookie-cutter website.

Replace the formatter board.   (On the 5si, 8000, 8100 this could be a fuser problem. Numeric Error Codes 0 - 19 (HP LaserJet) Numeric Error Codes 20 - 49 (HP LaserJet) Numeric Error Codes 50-59 (HP LaserJet) Numeric Error Codes 60 and up (HP LaserJet) Text Explanation: Check for obstructions in the printhead area.